Application

Silicone & Sealant

Vacuum deaeration, uniform dispersion up to millions of cP

Silicone & Sealant

Silicone sealant is highly viscous (tens of thousands to millions of cP) and requires strong kneading for uniform filler dispersion. Vacuum deaeration removes bubbles and heating controls crosslinking temperature. Vertical or horizontal bottom-discharge kneaders are recommended.

Production Process & Kneading Stage

Typical silicone sealant line: mixing/dispersing base polymer (107 hydroxy-terminated PDMS) with reinforcing fillers → plasticizer/additive blending → vacuum deaeration → crosslinker compounding → filling. The kneader owns the front-end dispersion step, which determines mechanical properties, appearance and storage stability — fumed silica agglomerates must be de-agglomerated under high shear and fully wetted by the base polymer.

Typical kneading sequence:

  1. Premix: base polymer plus part of the plasticizer at low speed to build initial flow;
  2. Filler dispersion: fumed/precipitated silica charged in 2-3 portions, tip speed about 0.5-1.5 m/s, each portion fully wetted before the next;
  3. Vacuum deaeration: below -0.095 MPa for 20-40 min to remove entrained air, moisture and volatiles;
  4. Cool-down & compounding: jacket cooling below 40 °C before crosslinker/catalyst addition to prevent premature curing;
  5. Discharge: bottom or screw discharge straight to the filling line.

Key controls: temperature throughout dispersion (exothermic), vacuum level and time (bubble rate), cleaning residue between grades (clarity of transparent products).

Material Characteristics → Equipment Requirements

Material characteristicProcess impactEquipment requirement
Wide viscosity range (tens of thousands to millions mPa·s)Poor low-speed mixing, high power at speedSigma-blade combination, low speed / high torque
Light, dusty, hard-to-wet fumed silicaCharging loss, agglomerationSealed charging port, high-shear kneading, wall scraper
Thixotropic, air-entrainingBubbles hard to expelVacuum below -0.095 MPa, negative-pressure mechanical seal
Crosslinker heat-sensitivePremature curing / gel scrapJacket cooling to below 40 °C
Sticky discharge, wall residueLow yieldHydraulic tilting or screw discharge, dead-zone-free bottom

In short, a silicone sealant kneader must combine high-shear dispersion, deep vacuum deaeration and staged temperature control; choose bottom or screw discharge to match the filling line.

Related Articles

Other Applications

Need process evaluation & selection?

Free material testing and process consulting - our engineers will recommend the right machine.

免费物料测试 24 小时响应 出口60+国家
Contact now